Showing posts with label speaker. Show all posts
Showing posts with label speaker. Show all posts
Tuesday, November 19, 2013
2 Way Speaker Crossover circuit
The series of crossover is an electronic circuit in which the point to separate the audio sound frequency. objective that only sound with a frequency range that can be accepted speakers are forwarded. less is more like a filter function, so the speakers work optimally.
2 way or 3 way or else, that determines how many channels would be separated voice. Each channel is handled by a single class of speakers. Eg 3 way, the frequency of sound produced by the head unit, separated by crossover as a low freq (big size distinguished speaker better known as the subwoofer), medium freq (medium speakers), usually in the middle) and hi freq (small speakers I would call a tweeter) Let me better sound and reduce noise.
2 way or 3 way or else, that determines how many channels would be separated voice. Each channel is handled by a single class of speakers. Eg 3 way, the frequency of sound produced by the head unit, separated by crossover as a low freq (big size distinguished speaker better known as the subwoofer), medium freq (medium speakers), usually in the middle) and hi freq (small speakers I would call a tweeter) Let me better sound and reduce noise.
 |
| Schematic 2 Way Speaker Crossover |
Friday, October 11, 2013
Woofer speaker amplifier circuit
In the circuit use a IC AN7171 . Minimum requirment voltage is 12 volt and maximum voltage is 15 volt . Power output 2 X 30 W with impedance 4 Ohm . Speaker match woofer speaker , and operate it on the small room. This circuit matches variety of input device such us mixer , equalizer , tone control , processor , galaxy , bass boost , giga bass , and etc.
This circuit schematic below :
 |
| AN7171 amplifier schematic |
Output speaker is stereo , output couple with ground and add commponent resistor 2,2 Ohm and capacitor 100 nF.
Saturday, September 14, 2013
Subwoofer Speaker box design
The order of 4 or sealed rear chamber bandpass system is essentially a system of watertight enclosures with the addition of an acoustic filter for the driver. The resulting system usually provides a lower cut-off frequency, the compromise that a larger case. The space can be reduced by two drivers in isobaric configuration.
4th-order bandpass systems generally show better able to handle the functions that the other major systems are considered. The transient response and is second only to the sealed enclosure systems, making it a good choice for subwoofer applications.
 |
| Subwoofer Speaker box design |
Since all output 4th order bandpass system is via the port, the largest diameter possible for the port area should be used to minimize noise from the port. The ports must be incinerated where possible, for the same reasons.
The 4th order bandpass system rarely allows a perfect bandpass response - there is usually an out-of-band noise present in the production. A notch filter can be used simply to reduce the noise as audible. Otherwise, a lowpass filter used in series with the driver, but the in-band response system may be affected if this approach is taken.
As the speaker sound 4th order band pass issued by the openings or ports on the port side of the box, the port noise inevitable.
This unwanted noise can be minimized by a notch filter and the largest diameter possible for the port of the area should definitely be used. Another option is to burn the ports of the 4th order bandpass room as this will certainly help to reduce unwanted extra from the subwoofer.
Subscribe to:
Posts (Atom)