What Must todo

Overview
The construction of the circuit has been increased to highlight and amplify video signals for further frequencies on image clarity.

Video Signal Amplifier Circuit diagram


Terminology

LH0024 – IC small signal IC designed for general purpose switching and amplification due to its low voltage, low voltage and three different win the election 1N4148 – silicon small signal diode planar epitaxial used for fast switching applications with a reverse voltage of 100 V and forward current of 150 mA

Circuit Explanation

In a video output signal is the high rate of frames selected for amplification of producing a finer. This is possible by placing the track between the video device and the reception lobby, where the video port of the television receiver is inserted. The construction is done simply by exploiting the operation of three transistors instead of IC and other supporting elements.

An isolator operating in the first phase of the Q1, which provides an interface for input impedance. Q2 manage the second phase, which leads to the common base configuration. In this phase, determine the earnings TR2 250 ohms cutting the lawn. To adjust TR2, it must be placed where an output voltage of 1 Vp-p is present, with a load of 75 ohms. The frequency response is regulated by a combination of R6, C3, and 500 ohms TR1. An output buffer is completed by Q3 of the third phase which provides an airline pilot with 75 ohms. The range of the circuit is stabilized with 12 V and 50 mA.

The series that we will make this is a special electronic circuit can be used to detect the presence or absence of signal AF / RF. The circuit is very neat and simple to make. Costs it takes quite cheap. If you are already assembling this circuit, then with easy reader determine whether there is AF or RF signal at a particular section of a circuit.

Basic circuit uses an audio amplifier and a loudspeaker with switch input for AF and RF signals. The whole device can be made small as possible so it can be included in a container to maintain security. Audio amplifier section in this series created by IC TDA 2822M, with low stereo power amplifier in 8-pin mini-DIP. IC is used as a bridge cofiguration to shrink to 250 mW output power, loudspeaker handle 4 ohm, 500mW. The current required is less than 10mA with voltage of 3V battery.

When the selector switch in the AF position, working on the input audio signal AF amplifier input (pin 7 of IC 1) through a capacitor C2 and potentiometer VR1. Capacitors C2 always hold input amplifier of the DC voltage and make it happen in the audio signal frequency. Input Signal IC 1 can be arranged with the help of potentiometers VR1.

When the selector switch in position RF and demodulator detector circuit formed by capacitor C1, diode D1, and resistors R1 and R2 are connected to the input The set. When the audio signal is detected then it will actually go kerangkaian to be strengthened. Signal detection is done by plugging probe (probe) on the legs of the existing components.

IC MSP 34X0G is a single chip that can process voice signals to all TV standard International, and very good for the digital NICAM stereo. In the IC has several advantages, namely:

A simple test circuit to fault find audio and radio equipment. Can be used to inject a square wave signal, rich in harmonics, or used with headphones as an audio tracer.

Signal Tracer and Injector Circuit diagram

a single pole double throw sitch is used to switch between inject and trace modes. The diagram is drawn in trace mode, the earpiece being connected to the collector of the last transistor. Both transistors are wired as emitter followers, providing high gain. DC blocking is provided by the 1n capacitor at the probe end, and the two stages are capacitively coupled.

When the switch is thrown the opposite way (to the blue dot) both transistors are wired as an astable square wave generator. This provides enough harmonics from audio up to several hundred kilohertz and is useful for testing AM radio Receivers.